PSSO HSP2800 Amplificatore 2x1400w 4ohm

Class H stereo PA amplifier with SMPS, 2 x 850 W RMS (8 ohms), 2 x 1400 W RMS (4 ohms)

• Stereo PA amplifier with class H circuitry
• Low weight and height due to integrated switch mode power supply
• Reliable power amp with high impulse stability for a wide range of applications (e.g. compact PAs, multi-way PAs, international concerts)
• Limiter and speaker switch-on delay
• 3 operating modes can be selected (stereo, parallel or bridged)
• 2 calibrated level controls for precise level adjustment
• Input sensitivity and limiter adjustable
• LED VU meter and LEDs for activated protective circuit (protect), overload (clip), and signal per channel
• LEDs for parallel and bridge mode
• Complete protection set against short-circuit, overheat, clipping, overload, DC voltage and VHF signals
• Highly efficient front-to-rear air routing
• Electronically balanced inputs via XLR mounting jacks, with XLR feed-through outputs
• Speaker outputs via lockable Speaker plugs and screw terminals
• Rugged steel chassis with aluminum front panel
• Rack installation with 2 units

• Power supply:	230 V AC, 50 Hz
  Power consumption:	1500,00 W 1/8 power
  Output power:	2 x 850 W RMS (8 ohms); 2 x 1400 W RMS (4 ohms)
  Frequency range:	20 – 20000 Hz
  Circuitry:	Class H
  Dimensions:	Width: 48,3 cm Depth: 50,5 cm Height: 8,9 cm
  Weight:	12,90 kg
  Power output (RMS):
  Stereo 4 ohms	2 x 1400 W
  Stereo 8 ohms	2 x 850 W
  8 ohms bridged	1 x 3000 W
  Signal-to-Noise ratio:	>90 dB
  Total harmonic distortion:	<0.1 %
  Damping factor:	>300
  Voltage gain:	38 dB
  Slew rate:	>20 V/µsec
  Crosstalk:	>70 dB
  Input sensitivity:	32 dB/1.0 V/0.775 V, swtichable
  Input impedance:	20 kohms (balanced), 10 kohms (unbalanced)
  Input connectors:	2 x XLR
  Output connectors:	2 x Speaker, screw terminals, 2 x XLR feed-through output
  Protection:	Overheat, overload, short-circuit, over-current, DC voltage, softstart, VHF signals
  Cooling:	2 temperature-controlled fans, front-to-rear
  Controls:	Power switch, input attenuators, mode switch stereo/parallel/bridged, input sensitivity
  LED indicators:	parallel, bridge (globally), protect, clip, signal (per channel)
  Construction:	Steel chassis, aluminum front panel
  	Rack installation with 2 U