Descrizione
Amplificatore Finale Digitale 1000w
•Stereo PA amplifier with class H circuitry
•LED VU meter and LEDs for activated protective circuit (protect), overload (clip), and signal per channel
•LEDs for parallel and bridge mode
•Complete protection set against short-circuit, overheat, clipping, overload, DC voltage and VHF signals
•Highly efficient front-to-rear air routing
•Electronically balanced inputs via XLR mounting jacks, with XLR feed-through outputs
•Speaker outputs via lockable Speaker plugs and scr
Power supply: 230 V AC, 50 Hz ~
Power consumption: 1000 W (1/8 power)
Power output (RMS):
Stereo 4 ohm 2 x 500 W
Stereo 8 ohm 2 x 310 W
8 ohm bridged 1 x 1000 W
Frequency response: 20-20000 Hz
Signal-to-Noise ratio: >80 dB
Total harmonic distortion: <0.1 %
Damping factor: >200
Voltage gain: 38 dB
Slew rate: >20 V/µsec
Crosstalk: >70 dB
Input sensitivity: 32 dB/1.0 V/0.775 V, switchable
Input impedance: 20 kohms (balanced), 10 kohms (unbalanced)
Input connectors: 2 x XLR
Output connectors: 2 x Speaker, screw terminals, 2 x XLR feed-through output
Protection: Overheat, overload, short-circuit, over-current, DC voltage, softstart, VHF signals
Cooling: 2 temperature-controlled fans, front-to-rear
Controls: Power switch, input attenuators, mode switch stereo/parallel/bridged, input sensitivity
LED indicators: parallel, bridge (globally), protect, clip, signal (per channel)
Construction: Steel chassis, aluminum front panel
Dimensions: 483 x 400 x 89 mm
Rack installation with 2 U
Weight: 8 kg
Shipping weight: 9.20 kg
